Set the temperature to the coldest setting, and wait for about an hour.Open the door, and check if the interior light lights up.Plug the power cord into the wall socket to turn the refrigerator on.Note that the carbon residue is harmless to humans.īy completing the following steps, the refrigerator should be fully functioning. If this happens, discard the first full load of ice. The first time you use the ice maker, or after you have replaced the water filter, the ice made by the ice maker may have a carbon residue.When the ice bucket is full, none of these noises will occur. Noises may occur when the ice maker is making ice or being supplied with water, or when ice cubes drop into the ice bucket.The ice cubes produced by the ice maker will drop into and scatter through out the freezer. Do not turn the ice maker on without the ice bucket in place.If you don’t intend to use the ice maker, or if you are going for a business trip or vacation, turn off the ice maker.When installation is complete, turn the refrigerator on, and then press Test Switch (A) on the ice maker to check if the ice maker operates and supplies water for the ice tray normally. Otherwise, the ice cubes from the ice maker will not collect in the bucket as intended.ħ. By design, the ice bucket is supposed to sit behind the ice maker. Put the ice bucket on the shelf as shown. Make sure the screw holes are aligned with each other before tightening the screws.Ħ. Tighten the provided screws (x2) to attach the ice maker firmly to the refrigerator. To prevent deviation of the ice maker, make sure the ice maker fits into position.ĥ. Then, push the ice maker inwards to the end. Insert the ice maker into the front side of the 2 grommets as shown. Make sure the connector is fully inserted to prevent system failure.Ĥ. Connect the wire connector of the ice maker to the socket (marked in the figure) on the main unit. Remove the screws (x2) from the cover, and then remove the cover by pulling it to the front.ģ. See the figure on the left, and then locate the cover on the inner upper corner of the main unit.Ģ. WARNING To prevent electrical shock, make sure the refrigerator is turned off before installation.ġ. To purchase a new auto ice maker (part type : RA-TIMO63PP/AA), visit the Samsung website or contact your retailer. STEP 6 Install the Auto Ice Maker (optional) Insert two door guards each to the freezer and the fridge. There are four door guards provided with the product. Unpack those accessories and put them in place. The accessories that ship with this refrigerator are properly packed for transportation and safety reasons. STEP 5 Unpack and put accessories in place Connect the water line installation kit (A) to the shut-off valve (B). Insert the pipe clamp (B) and the shutoff valve (C) into the cold water line (A).ģ. To assemble the water line installation kitĢ. After you have connected the water line, make sure the water storage tank inside the refrigerator is properly filled. For the ice maker to operate properly, a water pressure of 20-125 psi is required. Leave the legs at least (A) mm from the floor as shown.Ĭonnect the water line to the ice maker.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |